Use the supplied hardware listed in Step 1 and connect the shifter to the linkage. Be sure to use both flat washers, spacer and longer 60mm bolt.

Torque Spec: 16 lb-ft

Be sure to insert the supplied spacer so it is on the Right Hand side of the linkage. This is a pivot offset spacer and must be used with all weighted linkages.

The lower linkage bearing should spin freely after being tightened.

Due to the various types, shapes and brands of linkages, some bending/shaping of the eyelet may be necessary. Even brand new OEM Honda linkages are slightly wider than they should be.