David Cordell

You can use the K20Z1 engine and transmission but the engine wiring harness and ECU are not compatible with our conversion wiring. You will need to use the 02-04 engine wire harness and ECU along with a speed sensor converter.

The battery tray does not fit the FN2 and the filter bracket will need to be modified.

Please email support@hybrid-racing.com

Check out the Ultimate K-swap guide listed on our homepage. https://www.hybrid-racing.com/pages/the-ultimate-k-swap-guide

Sorry no, the TSX ECU is not compatible with the engine conversion. You should use only the 02-04 RSX ECU and engine wire harness.

You can see the image above for the compressor relay.

View this for wideband KPRO input settings: https://www.hondata.com/help/kmanager/in... The wire input signal is ELD pin E15.

The K20A engine from the Euro Accord CL7 is similar, but not the same as the K20A from the DC5 or EP3. Because of that our typical engine mounts will not work since the transmission is like that from the TSX (K24A2) You’d have to use the Hasport EKK3 mount kit if you plan to use the K20A Euro engine and trans. You’ll also need to use the Accord shifter and shifter cables as well.