Skip to main content
Editing Step 4 —

Step Type:

Drag to rearrange

To reinstall the alternator, first the supplied alternator bracket (as shown on the right in Figure 3a) must be installed. The bracket bolts up to the same two (2) holes the original A/C bracket bolted to (see Figure 3b). Use the 2 supplied black M10x1.25 bolts.

The bolts can be tightened with an 8 mm or 5/16” allen driver. Do not fully tighten the M10 bolts until after the alternator has been installed. This will aid in properly aligning the lower two (2) holes in the alternator with the threaded holes in the alternator bracket.

Once the alternator bracket has been bolted up, begin mounting the alternator by inserting the supplied 100 mm M8x1.25 bolt through the upper alternator mounting hole. Use n 6 mm allen wrench to tighten this bolt. This bolt should thread into the block where the top left mounting bolt for the A/C compressor originally went (as shown in Figure 3c).