Use the supplied T-bolt clamp and attach the intake tube to the throttle body.

We recommend keeping the plastic wrap on the intake tube to reduce the dirt that can get stuck to it during the install process. Remove it once it is installed.

Slide the silicone tube through the lower clamp and install the plastic velocity stack. Tighten the lower clamp onto the velocity stack.

Install the high flow dry air filter and secure it using the large worm-gear clamp.

The intake tube was designed to be used on larger, aftermarket throttle bodies, however it CAN be used on a stock K20A/A2 throttle body with a little bit of work. The clamp will be tight along the lower section of the throttle body port.