Determine where you want to install the IAT sensor. The sensor should be as close to the throttle body as possible.

We prefer putting it on the underside or in the back of the tube for a clean, hidden look.

Make sure you have your intake positions correctly. One side is marked "PRB" and the other side says "RBC". These markings will designate which section connects to the throttle body and is dependent on your intake manifold.

Use sensor: 37880-PLC-004

Using a drill, mark and drill the IAT sensor hole where you prefer. Be sure to size it correct so the sensor goes in and is completely sealed.

Clean the debris out of the intake tube using compressed air.