Engine
View
Options
Preview new Authoring Experience
History
1
2
3
4
5
6
7
8
9
10
Introduction
Details
Guide Steps
Review
Quiz
Using the supplied hardware, bolt the lower support bracket to frame rail.
Install the velocity stack and lower clamp mount and use the supplied bolt and tighten them together.
Install the high flow air filter and tighten all connections. Make sure the edge of the air filter does not contact the lower frame pinch weld.
Once all connections are tight, the intake system installation is complete. Re-install the front bumper & battery.
Fill the cooling system to capacity. You should not need to bleed the system as only a small amount of coolant should have been removed.
Due to the intake's high flow design, fine tuning of the fuel map may be required. Review your AFR (air fuel ratio) to insure optimal performance.
« Previous
Next »
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.