Where should I run the wire for the boost solenoid
Have the conversion harness just wanted to know where to put the wire for the boost solenoid?
Is this a good question?
Score
0
89
1 Answer
Wiring the Hondata Boost Control Solenoid
The solenoid has two wires, with no polarity (it does not matter which wire is used for each connection):
- One wire should be connected to the ECU pin B21 (which normally runs the purge control solenoid on the throttle body).
- One wire should be connected to +12V switched power via a 10A fuse.
Notes:
- Do not use a relay between the ECU and solenoid.
- High current solenoids could damage the ECU.
Was this answer helpful?
Score
0
