Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #7

Edit by Hybrid Racing

Edit approved by Hybrid Racing

Before
After
Unchanged

Step Lines

[* black] Find and locate the six wires that come off of the Hybrid Racing conversion harness at the ECU E PLUG and connect them using the following GUIDE.
[* black] CONNECT THE SIX WIRES AS OUTLINED BELOW:
[* black]  Connect E1 a GRN/YEL wire on the HR conversion harness to A16 a GRN/YEL wire on the STOCK CIVIC ECU CONNECTOR A. This wire controls the FUEL PUMP. *FOR Type R ECU disregard E1 a GRN/YEL wire on the HR conversion harness and GROUND A16 a GRN/YEL wire on the STOCK CIVIC ECU CONNECTOR A.
[* black] Connect E15 a GRN/RED wire on the HR conversion harness to A30 a GRN/RED wire on the STOCK CIVIC ECU CONNECTOR A. This wire controls the ELD.
[* black]  Connect E23 a BLU/YEL wire on the HR conversion harness to A21 a LTBLU or BLU/YEL wire on the STOCK CIVIC CONNECTOR A. This wire controls the DATA LINK CONNECTOR.
[* black]  Connect E26 a BLU wire on the HR conversion harness to A19 a BLU wire on the STOCK CIVIC CONNECTOR A. This wire controls the TACHOMETER.
[* black]  Connect E29 a BRN wire on the HR conversion harness to A10 a BRN wire on the STOCK CIVIC CONNECTOR A. This wire controls the SCS DATA LINK CONNECTOR.
[* black]  Connect E31 a GRN/ORN wire on the HR conversion harness to A18 a GRN/ORN wire on the STOCK CIVIC CONNECTOR A. This wire controls the CHECK ENGINE LIGHT.