Changes to Step #11

Edit by Hybrid Racing —

Edit approved by Hybrid Racing

Before
After
Unchanged

Step Lines

[title] Throttle Position Sensor
-[* 1] Use the supplied 12mm screws to install the TPS onto the throttle body housing. This throttle body was designed to work with OEM Honda & most aftermarket sensors. Because each brand TPS has a different calibration window (hall effect vs wiper, etc) it's highly recommended to use the engine management system to display the TPS value.
+[* 1] Use the supplied 12mm screws to install the TPS to the throttle body housing. This throttle body was designed to work with OEM Honda & most aftermarket sensors. Because each brand TPS has a different calibration window (hall effect vs wiper, etc) it's highly recommended to use the engine management system to display the TPS value.
[* 1] In most cases, setting the TPS in the center of the bolt holes will get it very close. Use the center bolts as a starting position, then verify and calibrate in the ECU software if necessary.
-[* 1] If you are NOT using an aftermarket engine management system, you must follow the OEM Honda TPS value procedure.
+[* 10] If you are NOT using an aftermarket engine management system, follow the OEM Honda TPS voltage value procedure.