Changes to Step #4
Edit by Hybrid Racing —
Edit approved by Hybrid Racing
- Before
- After
- Unchanged
Step Lines
| + | [title] Swap CMC and Install Clutch Line |
|---|---|
| + | [* 1] Using pliers, loosen clamp on reservoir hose at the CMC. Then immediately move hose to new CMC. |
| + | [* 1] Put the Clutch Line on the left side of Reservoir hose as shown in Picture 2. |
| + | [* 9] Ensure the angle of Clutch Line relative to CMC body is similar to Picture 2. If not, the Clutchline may interfere with Brake Vacuum Booster. |
| + | [* 1] Use a 14mm open ended wrench to tighten. |
| + | [* 9] ***DOUBLE CHECK*** that banjo washers and bolt are installed properly. |
Image 1
No previous image
Added
Image 2
No previous image
Added