Changes to Step #3
Edit by Hybrid Racing —
Edit approved by Hybrid Racing
- Before
- After
- Unchanged
Step Lines
| [title] Throttle Body Install | |
| [* 1] Check orientation of ZDX pattern thermal insulating gasket. Shown correctly in first picture. | |
| - | [* 1] Place throttle body and ZDX gasket on adapter. Fasten to adapter using x4 ***M8x1.25 50mm bolts*** and 4x ***Split Lock Washers***. Tighten to 16 lb-ft using 6mm Allen/Hex drive. |
| + | [* 1] Place throttle body and ZDX gasket on adapter. Fasten to adapter using x4 ***M8x1.25 50mm bolts*** and 4x ***Split Lock Washers***. |
| + | [* 10] Tighten to 16 lbf-ft using 6mm Allen/Hex drive. |