Changes to Step #2
Edit by Hybrid Racing —
Edit approved by Hybrid Racing
- Before
- After
- Unchanged
Step Lines
| [title] Adapter Installation | |
| [* 1] Check orientation of PRB pattern thermal insulating gasket. Correct orientation shown in first picture. | |
| - | [* 1] Place adapter and PRB gasket on manifold. Fasten adapter to manifold using x4 ***M8x1.25 20mm bolts***. Tighten to 16 lb-ft using 6mm Allen/Hex drive. |
| + | [* 1] Place adapter and PRB gasket on manifold. Fasten adapter to manifold using x4 ***M8x1.25 20mm bolts***. |
| + | [* 10] Tighten to 16 lbf-ft using 6mm Allen/Hex drive. |
| [* 10] Ensure that head of bolts are slightly recessed into adapter after tightening. | |
| [* 9] Do ***NOT*** use the split lock washers on this step. |