Changes to Step #2
Edit by Hybrid Racing —
Edit approved by Hybrid Racing
- Before
- After
- Unchanged
Step Lines
| + | [title] Adapter Installation |
|---|---|
| + | [* 1] Check orientation of PRB pattern thermal insulating gasket. Correct orientation shown in first picture. |
| + | [* 1] Place adapter and PRB gasket on manifold. Fasten adapter to manifold using x4 ***M8x1.25 20mm bolts***. |
| + | [* 10] Tighten to 16 lbf-ft using 6mm Allen/Hex drive. |
| + | [* 10] Ensure that head of bolts are slightly recessed into adapter after tightening. |
| + | [* 9] Do ***NOT*** use the split lock washers on this step. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added