Changes to Step #2
Edit by Hybrid Racing —
Edit approved by Hybrid Racing
- Before
- After
- Unchanged
Step Lines
| - | [* 1] Insert wisdom here |
|---|---|
| + | [title] "EXTRA" Wire |
| + | [* 1] The Rywire engine harness has an "Extra" wire included in the harness. |
| + | [* 1] This can be used to control or display an additional external sensor, such as a boost controller, air pressure sensor, etc. |
| + | [* 1] There are two wires on the engine harness, they correspond with the C101 connector, pins 11 & 12. |
| + | [* 1] Be sure to check the continuity between each wire to confirm the pin locations as they are not labeled. |