Skip to main content

Changes to Step #4

Edit by David Cordell

Edit approved by David Cordell

Before
After
Unchanged

Step Lines

[* 1] Use the supplied T-bolt clamp and attach the intake tube to the throttle body.
+ [* 10] We recommend keeping the plastic wrap on the intake tube to reduce the dirt that can get stuck to it during the install process. Remove it once it is installed.
[* 1] Slide the silicone tube through the lower clamp and install the plastic velocity stack. Tighten the lower clamp onto the velocity stack.
[* 1] Install the high flow dry air filter and secure it using the large worm-gear clamp.
[* 10] The intake tube was designed to be used on larger, aftermarket throttle bodies, however it CAN be used on a stock K20A/A2 throttle body with a little bit of work. The clamp will be tight along the lower section of the throttle body port.