Changes to Step #4
Edit by Hybrid Racing —
Edit approved by Hybrid Racing
- Before
- After
- Unchanged
Step Lines
| [title] B18 (all) & B16B (JDM) | |
| [* 1] Use the supplied hardware listed in Step 1 and connect the shifter to the linkage. Be sure to use both flat washers, spacer and longer 60mm bolt. | |
| - | [* 10] Torque Spec: 16 lb-ft |
| + | [* 10] Torque Spec: ***16 lb-ft*** |
| [* 9] Be sure to insert the supplied spacer so it is on the Right Hand side of the linkage. This is a pivot offset spacer and must be used with all weighted linkages. | |
| [* 11] The lower linkage bearing should spin freely after being tightened. | |
| [* 9] Due to the various types, shapes and brands of linkages, some bending/shaping of the eyelet may be necessary. Even brand new OEM Honda linkages are slightly wider than they should be. |