Changes to Step #10
Edit by Hybrid Racing —
Edit approved by Hybrid Racing
- Before
- After
- Unchanged
Step Lines
| + | [title] Lower Bracket & Filter |
|---|---|
| + | [* 5] Using the supplied hardware, bolt the lower support bracket to frame rail. |
| + | [* 7] Install the velocity stack and lower clamp mount and use the supplied bolt and tighten them together. |
| + | [* 8] Install the high flow air filter and tighten all connections. Make sure the edge of the air filter does not contact the lower frame pinch weld. |
| + | [* 1] Once all connections are tight, the intake system installation is complete. Re-install the front bumper & battery. |
| + | [* 11] Fill the cooling system to capacity. You should not need to bleed the system as only a small amount of coolant should have been removed. |
| + | [* 10] Due to the intake's high flow design, fine tuning of the fuel map may be required. Review your AFR (air fuel ratio) to insure optimal performance. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added