Changes to Step #9

Edit by Hybrid Racing —

Edit approved by Hybrid Racing

Before
After
Unchanged

Step Lines

[title] Throttle Cable
-[* 5] Begin by threading one of mounting nuts and rubber boot down towards the end of the cable. Insert the throttle cable through the bracket bolted to your HR throttle body.
+[* 5] Begin by threading one of mounting nuts and rubber boot down towards the end of the cable. Insert the throttle cable through the bracket groove.
[* 2] Insert the cable end into the throttle body rotor.
[* 4] Insert the cable into the throttle body rotor groove so the cable is in line with the mounting bracket.
[* 10] Disconnecting the throttle cable from the pedal assembly can aid in installation.
-[* 3] Thread the backing nut towards the throttle cable and adjust the cable placement so that the butterfly is fully open when the pedal is depressed to its maximum.
+[* 3] Thread the backing nut towards the bracket and adjust the cable placement so that the butterfly is fully open when the pedal is depressed to its maximum.
[* 3] Tighten the throttle cable nuts together holding it to the throttle body bracket.