Changes to Step #1
Edit by Hybrid Racing —
Edit approved by Hybrid Racing
- Before
- After
- Unchanged
Step Lines
| + | [title] Prep the intake manifold |
|---|---|
| + | [* 9] A big bore throttle body should not be used on a manifold that has not been bored to match or exceed the diameter of the throttle body (ie, a 70mm throttle body can be used on a manifold that’s bored to 74mm, but not on a manifold that’s bored to 65mm) |
| + | [* 1] If you intend to bore the manifold yourself, use the supplied plastic gasket to trace out the bore before removing the studs. |
| + | [* 1] Remove the gasket and check to see that the traced circle as shown in the figure. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added