Changes to Step #1

Edit by Hybrid Racing —

Edit approved by Hybrid Racing

Before
After
Unchanged

Step Lines

[title] OEM Cable Removal
[* 1] First, remove the (2) cotter pins with your fingers.(Picture 1)
[* 10] The oem shifter cables are affixed to the transmission by (2) cotter pins and (2) “c”-shaped linkage clips.
[* 1] Next, with a flathead screwdriver pry up the back side of the “c” shaped linkage clip (Picture 2) then pry from the front, twisting the screwdriver (Picture 3).
[* 1] Once you have removed both clips you can slide the endlinks off of the transmission and completely remove the shifter cables from the transmission side.
[* 10] Set them aside so they can be pulled out from the bottom of the car later.
- [* 11] NOTE: pictured in Fig 1A are Hybrid Racing shifter cable bushings, the OEM bushings are rubber and may use a different style pin to hold them in.
+ [* 11] NOTE: pictured in the first image are Hybrid Racing shifter cable bushings, the OEM bushings are rubber and may use a different style pin to hold them in.