-
-
Begin by removing the shift knob & locking nut. (if equipped)
-
-
-
Gently pry the shift boot console upwards. Remove it completely.
-
-
-
Gently unsnap the rear section of the console and remove it to expose the shifter assembly.
-
Remove the two mounting screws.
-
-
-
Pull down on the passenger side lower dash panel to expose the center console mounting clips.
-
Remove the mounting clips on both sides of the center console.
-
Be sure to save the clips, you will need them for reassembly.
-
-
-
Remove the two mounting screws located inside of the center console compartment.
-
Once all of the screws have been removed, pull the entire console backwards.
-
-
-
Once the shifter assembly has been fully exposed, remove the 3 mounting bolts.
-
-
-
Push the metal base out of the rubber bushing.
-
-
-
Remove the rubber insert.
-
-
-
Install the aluminum base bushing using the supplied hardware.
-
Re-assembly is the reversal of removal. Follow this guide in reverse to finish the job!
-