Skip to main content

You're viewing a previously published revision of this guide.  View latest revision

Older Newer
  1. Begin by disconnecting the positive terminal battery, then remove the negative terminal. Begin by disconnecting the positive terminal battery, then remove the negative terminal. Begin by disconnecting the positive terminal battery, then remove the negative terminal.
    • Begin by disconnecting the positive terminal battery, then remove the negative terminal.

  2. Unbolt the battery tie-down bracket and remove it. Unbolt the battery tie-down bracket and remove it. Unbolt the battery tie-down bracket and remove it.
    • Unbolt the battery tie-down bracket and remove it.

  3. Remove the battery, heat shield and unbolt the lower battery tray. Remove the battery, heat shield and unbolt the lower battery tray. Remove the battery, heat shield and unbolt the lower battery tray.
    • Remove the battery, heat shield and unbolt the lower battery tray.

  4. Loosen the intake tube clamp, slide it off of the airbox and then unplug the MAF sensor. Loosen the intake tube clamp, slide it off of the airbox and then unplug the MAF sensor. Loosen the intake tube clamp, slide it off of the airbox and then unplug the MAF sensor.
    • Loosen the intake tube clamp, slide it off of the airbox and then unplug the MAF sensor.

  5. Remove the wire harness from the airbox. Remove the wire harness from the airbox.
    • Remove the wire harness from the airbox.

  6. Unscrew the upper airbox lid. There are four screws that hold it in place.
    • Unscrew the upper airbox lid. There are four screws that hold it in place.

  7. Remove the lower airbox base by unbolting the 10mm mounting bolts. Pull the airbox up and remove it from the engine bay. Pull the airbox up and remove it from the engine bay.
    • Remove the lower airbox base by unbolting the 10mm mounting bolts.

    • Pull the airbox up and remove it from the engine bay.

  8. Locate the reverse solenoid on the top of the transmission and unplug the green connector. Locate the reverse solenoid on the top of the transmission and unplug the green connector.
    • Locate the reverse solenoid on the top of the transmission and unplug the green connector.

  9. Locate both detent springs. There is one on the front of the transmission gear selector and one on the side.
    • Locate both detent springs.

    • There is one on the front of the transmission gear selector and one on the side.

    • The one on the side is down near the base of the transmission mount.

  10. Insert wisdom here.
    • Insert wisdom here.

  11. Insert wisdom here. Insert wisdom here. Insert wisdom here.
    • Insert wisdom here.

  12. Insert wisdom here. Insert wisdom here. Insert wisdom here.
    • Insert wisdom here.

  13. Insert wisdom here. Insert wisdom here.
    • Insert wisdom here.

Hybrid Racing

Member since: 4/29/14

14,019 Reputation

76 Guides authored

View Statistics:

Past 24 Hours: 5

Past 7 Days: 15

Past 30 Days: 90

All Time: 2,463