-
-
Before you begin, you must select one of the two included spacers. The spacer should fit precisely on the gear selector pin.
-
-
-
Once you have determined which pin to use, push it through the beating. Make sure you install it with the retaining ring on TOP.
-
The spacer is also part of the bushing and the shifter cable will require the spacer to be on the bottom. The laser-etched face is the top.
-
Once the spacer is locked into the bearing, you can now proceed with the installation.
-
-
-
Insert the shifter cable end link onto the gear selector.
-
Then, install the cable through the transmission bracket. Secure with the supplied C clip.
-
-
-
Install the shifter cable onto the gear selector pin.
-
Then, push the shifter cable through the shifter cable bracket and secure it with the supplied C clip.
-
-
-
Install the cable through the shifter bracket.
-
Slide the end link onto the shifter pin.
-
Secure the cable with the shifter C clip.
-
-
-
Insert the cable through the shifter.
-
Secure with the shifter C clip.
-
Under the shifter, slide the cable onto the ball. Make sure it clips into place and does not slide off.
-
-
-
Be sure to install the cotter pin through the end link and use a wrench to tighten the end link nut.
-
Shift through all gears and confirm everything is smooth.
-
Almost done!
Finish Line