Difficulty
Moderate
Steps
4
Time Required
In Progress
This guide is currently being written. Reload periodically to see the latest changes.
Private
This guide will not appear in search results and can only be viewed by team members!
Quiz
0
-
-
Remove the Cotter Pin and Clevis Pin
-
Inspect the Clevis Pin for wear. On high-mile 04-08 TSX, we have seen clutch petal cause wear on the pin. If it is worn, you can reuse, but plan to replace.
-
Remove x2 M8x1.25mm nuts holding CMC to Firewall.
-
Use a 12mm deep-socket (preferably on 1/4-drive rachet)
-
-
-
Remove the x1 M6x1.0 bolt mounting reservoir to strut tower. Use a 10mm socket and extension.
-
The reservoir hose does not need to be removed from CMC yet. As you will see in later steps, the CMC and Reservoir and be pulled out together.
-
-
-
If OE clutch hardline still in use, first remove clutchline from CMC.
-
If you already have a flexible braided clutch line, save yourself the mess and DO NOT remove from CMC yet.
-
Push the reservoir into cavity between firewall and strut tower. Then pull it underneath the Brake Master Cylinder.
-
Pull the OE CMC out of firewall. Then pull CMC out, following same route underneath the Brake Master.
-
-
-
Using pliers, loosen clamp on reservoir hose at the CMC. Then immediately move hose to new CMC.
-
Install Hybrid Racing clutchline onto CMC.
-
