Difficulty
Moderate
Steps
4
Time Required
- HYB-CAI-01-02 4 steps
In Progress
This guide is currently being written. Reload periodically to see the latest changes.
User-Contributed Guide
This guide is not managed by the site's staff.
Private
This guide will not appear in search results and can only be viewed by team members!
Quiz
0
-
-
Before you begin, unbox and locate all of the parts in the K-Swap Cold Air Intake kit.
-
x1 Intake tube, x1 3 inch velocity stack with dry element filter, x1 valve cover breather, x1 stainless t-bolt clamp, x1 mounting clamp, x1 lower mounting bracket & hardware pack.
-
-
-
This kit fits all 92-00 Honda Civic & 94-01 Integra frames. Under the LH side frame rail, located the threaded hole.
-
Using the supplied hardware, bolt the bracket to the threaded hole in the frame.
-
Use the remaining hardware to connect the mounting clamp to the bracket. Do not tighten at this time.
-
-
-
Determine where you want to install the IAT sensor. The sensor should be as close to the throttle body as possible.
-
We prefer putting it on the underside or in the back of the tube for a clean, hidden look.
-
Make sure you have your intake positions correctly. One side is marked "PRB" and the other side says "RBC". These markings will designate which section connects to the throttle body and is dependent on your intake manifold.
-
Use sensor: 37880-PLC-004
-
Using a drill, mark and drill the IAT sensor hole where you prefer. Be sure to size it correct so the sensor goes in and is completely sealed.
-
Clean the debris out of the intake tube using compressed air.
-
-
-
Use the supplied T-bolt clamp and attach the intake tube to the throttle body.
-
